The Domestic Rubber Accelerator Market Inventory In 2010
Throughout the whole year of 2010, rubber accelerator market as a whole showed a narrow range of fluctuation of the situation. April and September of raw materials rose and demand increased and driven, rubber accelerator offer two brief rally ,Rubber accelerator offer two short up outside, the beginning of the year, in the end of years, main model M basic price is up to 15500 yuan per tons.The highest point of the annual price in October, rubber accelerator M roughly at 16,500 - 17,000 yuan per ton. This year, the market no matter up or down, are relatively flat, it is difficult to the form of ups and downs in previous years. The reason mainly lies in the rubber accelerator manufacturers through continuous expansion of domestic production capacity to spread, manufacturers of hard to concentrate on a unified pull price. And low and high spread, causing the market price than confusion.
Rubber accelerator market in 2010 the main factor:
1. The trend of the main raw material for products such as aniline, sulfur rubber accelerator market is significant. Rubber accelerator agent market price is basically to keep up with the prices of raw materials, by the influence of raw material prices.
2. The "Eleventh Five" emission reduction plan makes the most parts of the power cuts, rubber accelerator production and sales are subject to a certain extent. Tianjin, Henan, Jiangsu and Zhejiang region many of the major rubber accelerator manufacturers to start in the third quarter decreased to less than 5 percent, the manufacturers supply was tight, offer up. Downstream some manufacturers started to have been affected slightly reduced demand.
3. The Fed announced on November 4, they start the second round of quantitative easing program to purchase $ 600 billion in assets total. To save the national downturn in the economy, the United States economy a massive injection of liquidity, causing depreciation of the dollar and exacerbate the commodities rally in the international market. This makes imported inflationary pressures in China has been increasing. Since the third quarter, the prices of natural rubber, synthetic rubber continued to surge, the majority of loss of downstream tire factory and rubber products factory, started to reduce the large tire factory started in the fourth quarter of about 7 percent, part of the rubber products enterprises have ceased production.
4. Inflationary pressures continue to heat up the monetary policy continued to tighten. Domestic raw material prices continue to skyrocketing, inflationary pressures are growing wider, since October 2010, the central bank raised benchmark deposit and lending rates of financial institutions, increase the deposit-taking financial institutions of RMB deposit reserve ratio, the cumulative extent of 0.5% and 1.5% respectively. Domestic policy into the contraction cycle as a whole, to suppress the formation of commodity prices. November-December, commodity prices have come down gradually, rubber accelerator raw material aniline, sulfur prices have fallen sharply, driven by rubber accelerator agent at the end of the price lower.
5. Automobile production and sales is after the first or lift. In 2010, China's automobile market is showing "high open stabilize situation, the China Automotive Technology and Research Center data show that vehicle production more than 1.5 million in January, made a good start; March car production reached the highest ever single month in China's auto output, close to 1.7 million; by the terminal sales of the automotive market downturn, the yield decreased month by month, and year-on-year rate of increase gradually slowed down. Beginning in April, with the automobile market supply is increasingly sufficient, coupled with favorable policies, the pulling effect of weakening consumer hold out situation aggravate rising inventories, accompanied by the arrival of the season in the second half of the year to July, automobile production and sales began to rise. July to November, showing a rebound trend.